Two Component Load Cell
OSC92OT103
Features
-It is a device for control and regulation of the blade slope of the grader.
-The device enables the operator to keep the blade slope at necessary angle with the help of sound and light signals.
-It comprises two blocks;
Slope sensor with signal precision amplifer
Slope measuring and control unit
-The slope measuring and control unit is fixed to the suitable for the operator place in the grader cab.
-The unit enables to feed the desired blade slope with the admissible deviation.
-If the blade slope goes out from the limits the measuring and control unit will give the light and sound signals which help the operator to regulate the balde slope back to the necessary value.
| Model | OSC 92OT103 | |||||||||
| Rated output | Approx. 0.5mV/V(approx. 1000x10-6 strain) | |||||||||
| for each component force | ||||||||||
| Non-linearity | }0.2%FS for each component force | |||||||||
| Hysteresis | }0.2%FS for each component force | |||||||||
| Allowed overload | }150%FS for each component force | |||||||||
| Cross talk* | -Between the measured component forces | |||||||||
| : }2%FS/FS | ||||||||||
| -By other component forces | ||||||||||
| : }3%FS/FS | ||||||||||
| Temperature influence on the zero point | }0.01%FS/ | |||||||||
| for each component force | ||||||||||
| Temperature influence on the sensitivity | }0.05%Reading/ | |||||||||
| for each component force | ||||||||||
| Cable connection | NDI connector length = 5m | |||||||||
pdf brochure